Figure 159. Removing a 2.5-inch hot-swap drive
Remove a 3.5-inch hot-swap drive:
a.
Slide the release latch to unlock the drive handle.
b.
Rotate the drive handle to the open position.
c.
Grasp the handle and slide the drive out of the drive bay.
Note: Install a drive bay filler or replacement drive as soon as possible. See “Install a 2.5-/3.5-
inch hot-swap drive” on page 230.
Figure 160. Removing a 3.5-inch hot-swap drive
After you finish
If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Chapter 4. Hardware replacement procedures 229
To Next Page
Loading...
