Lenovo ThinkSystem SR670 V2 - Page 239

Figure 162. 3.5-inch drive bay numbering
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Based on your configuration, follow the corresponding procedures to install a 2.5-inch or 3.5-inch
hot-swap drive.
Install a 2.5-inch hot-swap drive:
Note: If a drive bay filler is installed in the drive bay, pull the release lever on the filler and slide it
out of the server.
a.
Make sure that the drive handle is in the open position. Then, align the drive with the guide
rails in the bay and gently push the drive into the bay until the drive stops.
b.
Rotate the drive handle to the fully closed position until the handle latch clicks.
Figure 163. Installing a 2.5-inch hot-swap drive
Install a 3.5-inch hot-swap drive:
Note: If a drive bay filler is installed in the drive bay, pull the release lever on the filler and slide it
out of the server.
Chapter 4. Hardware replacement procedures 231