Figure 182. Removing the EDSFF drive cage assembly
After you finish
• Install a replacement unit. See “Install the EDSFF drive cage assembly” on page 247.
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the EDSFF drive cage assembly
Follow instructions in this section to install the EDSFF drive cage assembly.
About this task
Attention:
• Read “Installation Guidelines” on page 121 and “Safety inspection checklist” on page 122 to ensure that
you work safely.
• Touch the static-protective package that contains the drive to any unpainted metal surface on the
solution; then, remove the drive from the package and place it on a static-protective surface.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku: https://list.youku.com/albumlist/show/id_59636529
Procedure
Chapter 4. Hardware replacement procedures 247
To Next Page
Loading...
