Figure 244. Thermal grease application
After you finish
1. Follow the instructions below to install the L2A.
a. Lift up the cold plate.
Slightly lift up the cold plate with your right hand, and hold the cold plate assembly lifting handle
with your left hand from underneath the cold plate.
Remove your right hand from the cold plate while holding the cold plate assembly lifting handle
with your left hand.
Figure 245. Lifting up the cold plate
b. Rotate the L2A clockwise.
Hold the bottom edge of the radiator, and hold the cold plate assembly lifting handle from
underneath.
Rotate the L2A clockwise so that the left end of the radiator is standing on the flat surface, and the
cold plate assembly lifting handle is facing your left side. Move your right hand to hold the right end
of the radiator which is attached with the tubes.
310
ThinkSystem SR670 V2 Maintenance Manual
To Next Page
Loading...
