Lenze 8400 HighLine C Series - 14.2.26.1 Configuring the list using the Engineer parameterisation dialog

8400 HighLine | Parameter setting & configuration
Function library
System blocks | LS_WriteParamList
1092 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
14.2.26.1 Configuring the list using the »Engineer« parameterisation dialog
In the »Engineer«, the following parameterisation dialog is available for user-friendly
creation of the parameter list and entry of the parameter values:
C01088/1 ... 32 -2147483647 2147483647 Parameter values - value set 3
• Parameter values for the
parameters defined in C01085/
1 ... 32.
C01089/1 ... 32
-2147483647 2147483647 Parameter values - value set 4
• Parameter values for the
parameters defined in C01085/
1 ... 32.
Parameter Possible settings Info
efesotomasyon.com - Lenze