Lenze 8400 HighLine C Series - 14.1.22.4 Function 4: |nIn1| = |nIn2|; 14.1.22.5 Function 5: |nIn1| > |nIn2|; 14.1.22.6 Function 6: |nIn1| < |nIn2|

8400 HighLine | Parameter setting & configuration
Function library
Function blocks | L_Compare_1
900 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
14.1.22.4 Function 4: |nIn1| = |nIn2|
This function serves to implement e.g. the comparison "n
act
= 0". This function is similar to
function 1. However, the amount is generated by the input signals before signal processing
(without sign).
Function 1: nIn1 = nIn2
14.1.22.5 Function 5: |nIn1| > |nIn2|
This function serves to implement the comparison "|n
act
|>|n
x
|" independent of the
direction of rotation. This function is similar to function 2. However, the amount is
generated by the input signals before signal processing (without sign).
Function 2: nIn1 > nIn2
14.1.22.6 Function 6: |nIn1| < |nIn2|
This function serves to implement the comparison "|n
act
|<|n
x
|" independent of the
direction of rotation. This function is similar to function 3. However, the amount is
generated by the input signals before signal processing (without sign).
Function 3: nIn1 < nIn2
efesotomasyon.com - Lenze