Lenze 8400 HighLine C Series - 14.1.27.4 Function 4: |dnIn1| = |dnIn2|; 14.1.27.5 Function 5: |dnIn1| > |dnIn2|; 14.1.27.6 Function 6: |dnIn1| < |dnIn2|

Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 909
8400 HighLine | Parameter setting & configuration
Function library
Function blocks | L_ComparePhi_1
14.1.27.4 Function 4: |dnIn1| = |dnIn2|
This function serves to implement e.g. the comparison "n
act
= 0". This function is similar to
function 1. However, the amount is generated by the input signals before signal processing
(without sign).
Function 1: dnIn1 = dnIn2
14.1.27.5 Function 5: |dnIn1| > |dnIn2|
This function serves to implement the comparison "|n
act
|>|n
x
|" Independent of the
direction of rotation. This function is similar to function 2. However, the amount is
generated by the input signals before signal processing (without sign).
Function 2: dnIn1 > dnIn2
14.1.27.6 Function 6: |dnIn1| < |dnIn2|
This function serves to implement the comparison "|n
act
|<|n
x
|" independent of the
direction of rotation. This function is similar to function 3. However, the amount is
generated by the input signals before signal processing (without sign).
Function 3: dnIn1 < dnIn2
efesotomasyon.com - Lenze