Lenze 8400 HighLine C Series - 12.1.3.3 Parameters with bit-coded setting

8400 HighLine | Parameter setting & configuration
Parameter reference
Structure of the parameter descriptions
582 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Parameter setting in the »Engineer«
In the »Engineer«, a list field is used for parameter setting:
12.1.3.3 Parameters with bit-coded setting
Description structure
Parameter setting in the »Engineer«
The »Engineer« uses a dialog box for parameter setting in which the individual bits can be
set or reset. Alternatively, the value can be entered as a decimal or hexadecimal value:
Parameter | Name:
Cxxxxx | _____________
Data type: _______
Index: _______
Description
Value is bit-coded:
Bit 0
...
Bit 31
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
efesotomasyon.com - Lenze