Lenze 8400 HighLine C Series - 8.12.2 Parameter setting

Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 439
8400 HighLine | Parameter setting & configuration
Basic drive functions (MCK)
Holding brake control
8.12.2 Parameter setting
Parameterisation dialog in the »Engineer«
 Danger!
A faultless brake control function requires a correct setting of the different
deceleration times in the following parameters!
A wrong setting of the delay times can cause a faulty control of the brake!
efesotomasyon.com - Lenze