8400 HighLine | Parameter setting & configuration
System bus "CAN on board"
Parameter data transfer
530 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
10.8 Parameter data transfer
[10-8] Parameter data transfer via the available parameter data channels
Parameters are values stored in codes on Lenze controllers.
Two parameter data channels are available for parameter setting, enabling the
simultaneous connection of different devices for configuration purposes.
Parameter data are transmitted via the system bus as SDOs (Service Data Objects) and
acknowledged by the receiver. The SDO enables read and write access to all device
parameters and to the CANopen object directory integrated in the device. Indices (e.g.
0x1000) ensure access to device parameters and functions included in the object directory.
To transfer SDOs, the information contained in the user data must comply with the CAN
SDO protocol.
efesotomasyon.com - Lenze
To Next Page
Loading...
