Lenze 8400 HighLine C Series - C00953 | L_Interpolator_1: Filters; C00960 | L_Curve_1: Selection of the curve shape; C00961 | L_Curve_1: Input limitation; C00963 | L_Curve_1: Table of X values

Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 753
8400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00953
C00953
C00960
C00961
C00963
Parameter | Name:
C00953 | L_Interpolator_1: Filters
Data type: UNSIGNED_8
Index: 23622
d
= 5C46
h
As of version 04.00.00
L_Interpolator_1
FB: Filters
Setting range (min. value | unit | max. value) Lenze setting
0
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00960 | L_Curve_1: Selection of the curve shape
Data type: UNSIGNED_8
Index: 23615
d
= 5C3F
h
As of version 04.00.00
L_Curve_1
FB: Selection of the function
Selection list
0Out = 0
1Out = In
2Out = f(In)
3Out = f(table)
Subcodes Lenze setting Info
C00960/1 1: Out = In L_Curve_1
: Function
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
Parameter | Name:
C00961 | L_Curve_1: Input limitation
Data type: INTEGER_16
Index: 23614
d
= 5C3E
h
As of version 04.00.00
L_Curve_1
FB: Upper and lower limit for input value
Setting range (min. value | unit | max. value)
-199.99 % 199.99
Subcodes Lenze setting Info
C00961/1 199.99 % L_Curve_1
: Max. input
C00961/2 -199.99 % L_Curve_1: Min. input
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 100
Parameter | Name:
C00963 | L_Curve_1: Table of X values
Data type: INTEGER_16
Index: 23612
d
= 5C3C
h
As of version 04.00.00
L_Curve_1
FB: X values for characteristic function
Setting range (min. value | unit | max. value)
-32767 32767
Subcodes Lenze setting Info
C00963/1 32767 X values 1 ... 32 for characteristic function
C00963/...
C00963/32
; Read access ; Write access  CINH  PLC STOP  No transfer  COM  MOT Scaling factor: 1
efesotomasyon.com - Lenze