Lenze 8400 HighLine C Series - 5.13 Internal status signals | system block LS_DeviceMonitor

8400 HighLine | Parameter setting & configuration
Motor control (MCTRL)
Internal status signals | system block "LS_DeviceMonitor"
214 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
5.13 Internal status signals | system block "LS_DeviceMonitor"
The LS_DeviceMonitor system block provides the status signals of the motor control in the
function block editor.
 Note!
The LS_DeviceMonitor system block can only be inserted on the application
level.
If status signals of the motor control function are to be output via digital outputs
or example, you can use the free bFreeOut1 ... bFreeOut8 outputs of the
application block to transfer the desired status signals from the application level
to the I/O level. On the I/O level, you can then establish the logical link to the
digital output terminals.
efesotomasyon.com - Lenze