8400 HighLine | Parameter setting & configuration
Motor control (MCTRL)
Parameterisable additional functions
178 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
[5-25] Example 2: Signal characteristic for automatic DC-injection braking of a drive with speed feedback
Speed setpoint
Actual speed value of the motor
Output current of the controller
Pulse inhibit
DC-injection braking is active
c The motor rotates at the
selected speed. The resulting
current depends on the load, see
.
d The DC braking current set in
C00036
is injected.
e The actual speed value of the
motor follows the speed setpoint.
The resulting current depends on
the load.
0
1
2
3
4
C00036
C00019
efesotomasyon.com - Lenze
To Next Page
Loading...
