Lenze 8400 HighLine C Series - Page 251

Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 251
8400 HighLine | Parameter setting & configuration
I/O terminals
User-defined terminal assignment
Possibility 3: Change terminal assignment with the FB editor
Procedure:
1. Go to the FB Editor tab.
2. Delete the existing interconnection from LS_DigitalInput.bIn2 to LA_NCtrl.bJogSpeed2:
3. Establish a new interconnection from LS_DigitalInput.bIn2 to LA_NCtrl.bJogRamp1:
 Tip!
You can find detailed information on how to use the FB editor of the »Engineer« in
the main chapter entitled "Working with the FB Editor
". ( 820)
efesotomasyon.com - Lenze