Lenze 8400 HighLine C Series - Page 28

8400 HighLine | Parameter setting & configuration
Introduction: Parameterising the controller
Handling the memory module
28 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
Delivery
 All devices are delivered with a plugged-on memory module.
 In the delivery state, the Lenze setting of the parameters is stored in the memory
module.
 The memory module can be preconfigured with customer-specific data.
 The memory module is available as a spare part - without any data.
During operation
 Plugging and unplugging the memory module results in a message.
 Full functionality of the memory module is even provided if the power supply has been
switched off and only the electronic components of the controller are externally
supplied by a 24 V DC voltage, e.g. via the X5/24E terminal.
 Parameter sets can be saved manually.
 Parameter sets can be loaded manually.
 Note!
Automatic saving is explicitly not supported because this significantly reduces
the service life of the memory module.
efesotomasyon.com - Lenze