Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 39
8400 HighLine | Parameter setting & configuration
Commissioning
Quick commissioning
4. Set keypad control
5. Enable controller:
Set terminal X5/RFR to HIGH potential (reference: X5/24I).
6. Use the keypad to change the motor velocity or
the motor speed by selecting different fixed setpoints:
• Scroll to the bottom from the
"User menu" with the button to
the "Quick commissioning" menu
• Click on right-hand button
• Select the "Keypad" menu
• Click on right-hand button
• Code C00002/1:
–Parameterise "Edit" using the
left function key
–Select value "1" ---> On/Start
and confirm with "OK" function
key on right
During loading the Lenze setting, the
display goes off for a short time.
• With the Lenze setting, the
"Actuating drive speed"
technology application is
implemented.
• When the display reappears, the
main menu is shown.
–The main menu can be set in a
user-defined manner via the
codes C00465 ... C00469.
• Use the left function key to go to
the USER menu
• Continue as described in
commissioning point 3:
–"Quick commissioning" menu
–Keypad
–Load Lenze setting
• With the "Bottom" navigation
key, code C00007 for selecting the
control mode is reached:
–Select code C00007 and
parameterise with "Edit"
–Select value "20" ---> "Keypad"
and confirm with "OK".
Keypad Code Subcode Motor speed
C00728 3 Counter-clockwise rotation:
-199.99 % ..... 0 (from C00011)
Clockwise rotation:
0 ... +199.99 % (from C00011)
C00051 - Display of actual speed value
SAVE
Par1 8400 HighLineC
User - Menu
Logbook
Go to param
Quick commissioning
SAVE
Par1 Quick commissioning
Terminals
Keypad
EDIT
Load Lenze setting
C00002/1
MCTRL: Act. speed val.
C00051
0 rpm
EDIT
Select CtrlMode
C00007
Quick commissioning
SAVE
Par1 Quick commissioning
Terminals
Keypad
SAVE
Par1 8400 HighLineC
User - Menu
Logbook
Go to param
Quick commissioning
EDIT
Load Lenze setting
C00002/1
EDIT
< ... >
C00728
C00051
SAVE
Par1 Quick commissioning
Terminals
Keypad
efesotomasyon.com - Lenze
To Next Page
Loading...
