Lenze 8400 HighLine C Series - Page 392

8400 HighLine | Parameter setting & configuration
Basic drive functions (MCK)
Basic settings
392 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
 Note!
An operated limit switch can only be retracted again in the "Manual jog"
operating mode, e.g. with the "Retract limit switch" function.Retracting of an
operated limit switch ( 413)
Bit 10 ("Pos. HW-Limit Detected") or bit 11 ("Neg. HW-Limit Detected") is also
reset in the MCK status word
by retracting the limit switch.
efesotomasyon.com - Lenze