8400 HighLine | Parameter setting & configuration
Diagnostics & error management
Drive diagnostics with the »Engineer«
456 L Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010
How to diagnose a drive with the »Engineer«:
1. Go to the Project view and select the 8400 controller to be diagnosed.
2. Click the icon or execute the OnlineGo online command to establish an online
connection to the controller.
3. Select the Diagnostics tab.
• With an online connection, the Diagnostics tab displays current status
information about the controller.
Tip!
The online connection to the controller can be established via the following device
interfaces:
• X1 CAN interface
Diagnostics via the System bus "CAN on board"
( 500)
• X6 diagnostic interface
We recommend this diagnostic connection when the X1 CAN interface is used
for process communication.
efesotomasyon.com - Lenze
To Next Page
Loading...
