Lenze 8400 HighLine C Series - Page 59

Firmware ≤ 05.00 - DMS 4.2 EN - 02/2010 L 59
8400 HighLine | Parameter setting & configuration
Commissioning
Commissioning the "Table positioning" TA using the »Engineer«
More detailed information on the technology application:
TA "Table positioning"
( 291)
Basic signal flow
( 292)
Internal interfaces | Application block "LA_TabPos"
( 295)
Control words wCANDriveControl/wMCIDriveControl
( 304)
Terminal assignment of the control modes
( 305)
Setting parameters (short overview)
( 321)
Configuration parameters (short overview)
( 322)
efesotomasyon.com - Lenze