LulzBot Mini - Example Print with Variable Layer Height; Example with Skipped Layers

Slic3r
Fig. 2.54 shows the example model printed. The print on the left has
0.4mm layer height throughout, whereas the print on the right has the
variable layer height.
Figure 2.54: Example print with variable layer height.
An additional feature of the variable layers height option is that by
entering a zero for a range that part of the model will not be printed. Fig.
2.55 shows the G-Code where layers between 0 and 4mm are skipped. This
is a useful way of dividing a tall model into multiple, shorter subsections
which can be printed individually and assembled afterwards.
Figure 2.55: Example with skipped layers.
108