3D Printer Software
python-pyglet python-tornado python-setuptools
python-libxml2 python-gobject python-pip avahi-daemon
libavahi-compat-libdnssd1 followed by: pip install -r
requirements.txt To install in a terminal issue the following
command: sudo python setup.py install. Run Printrun by
issuing the following command: python pronterface.py
Fedora
• Use this command to install Printrun from the official sources: sudo
yum install printrun
Archlinux
• Use this command to install Printun from AUR: yaourt rintrun
1.24 Using Printrun
Figure 1.19: Printrun
44
To Next Page
Loading...
