LulzBot Mini User Manual

Slic3r
support automatically, otherwise the degrees given will be used. Support
generation is a relatively complex topic, and there are several aspects
which determine the optimal support, it is strongly recommended to set
the threshold to zero and allow Slic3r to determine the support required.
Small models, and those with small footprints, can sometimes break or
detach from the bed. Therefore the Enforce support option will cause
support structures to be printed for the given number of layers, regardless
of the angle threshold value.
To demonstrate the infill patterns the minimug model was tilted by 45°
along the x axis, as shown in figure 2.38.
Figure 2.38: Minimug model, tilted 45°.
As with infill, there are several patterns available for the support
structure.
96

LulzBot Mini Specifications

General

Tweezers	Yes
Certification	CE, FCC, WEEE
Product color	Black, Green
Viewing window	No
Maximum print platform temperature	120 °C
Package weight	11330 g
AC input voltage	100/240 V
Power consumption (typical)	150 W
Print technology	-
Printing material	ABS, HIPS, Nylon, PVA, Polycarbonate (PC), Polylactic acid (PLA)
Layer thickness (max)	0.5 mm
Layer thickness (min)	0.05 mm
Maximum build size (WxDxH)	152 x 152 x 158 mm
Filament thickness supported	3 mm
Maximum vertical build speed	275 mm/sec
Printing compartment volume	3.65 L

Weight and Dimensions

Depth	435 mm
Width	340 mm
Height	385 mm
Weight	8550 g