3D Printer Software
speeds, and print speeds. Fine tuning these for specific STL files, can
produce cleaner prints.
Pause at Z Height
Pause your print at a specified height. You can also specify where to
move the print head and how much filament to retract. This will prevent
“blobs” from accumulating on your print while paused. This setting is most
commonly used when switching colors of filaments in the middle of a print.
1.13 Start and End Gcode Settings
Custom Gcode allows for complex automatic printer movements and
operations. By adding custom Gcode into the start or end of your
file, you can alter how it prints. A comprehensive list of Gcode
commands can be found here: http://reprap.org/wiki/G-code We
recommend new users to leave this as provided in the profiles at
https://www.lulzbot.com/support/downloads
Mini Specific Considerations
Please be cautious when changing any of these start and end gcode settings.
This is where your Auto Bed Leveling commands are stored. If improperly
altered, your printer will no longer automatically compensate for the heated
bed position and can even potentially damage components on the printer.
If you are uncertain of the change you are trying to make, please contact
us at Support@LulzBot.com before hand.
1.14 Expert Settings
Expert settings will give you more specific options for your retraction, skirt,
active cooling, infill, support, brim, raft, and special settings. To gain
access to this section you go to Expert > Open Full Settings or on your
keyboard press Control + E.
34
To Next Page
Loading...
Need help?
General
Weight and Dimensions
