Slic3r
Figure 2.20: Simple Mode: Printer Settings.
Size and coordinates. The Bed size setting is taken from the wizard (see
p.58) and is only used for previewing the model in the plater.
The Print center is the point around which the print will be centered.
A Bed size of 200mmx200mm and a Print center of 100mmx100mm
would sit the print in the middle. Should it be desired to print away from
the center, because of a scratch in the glass perhaps, then this option should
be used.
Z offset can be used to compensate for an incorrectly calibrated Z
end-stop. If the nozzle stops slightly too far from the bed, then adding a
78
To Next Page
Loading...
