2.2. GETTING SLIC3R
2.2 Getting Slic3r
Slic3r is Free Software, and is licensed under the GNU Affero General Public
License, version 3.
Downloading
From LulzBot
The Slic3r version that has been tested for the Mini 3D printer
can be downloaded from the LulzBot.com downloads page:
https://www.lulzbot.com/support/downloads.
Pre-compiled packages are available for Windows, Mac OS X and Linux.
Windows and Linux users can choose between 32 and 64 bit versions to
match their system.
Slic3r
Slic3r can be downloaded directly from: http://slic3r.org/download.
Pre-compiled packages are available for Windows, Mac OS X and Linux.
Windows and Linux users can choose between 32 and 64 bit versions to
match their system.
Manual
The latest version of full Slic3r manual, with L
A
T
E
X source code, can be
found at: https://github.com/alexrj/Slic3r-Manual
Source
The source code is available via GitHub: https://github.com/alexrj/Slic3r.
For more details on building from source see §2.2 below.
Installing
Linux
Extract the archive to a folder of your choosing. Either:
53
To Next Page
Loading...
