LulzBot Mini User Manual

Slic3r
6. Bed Temperature
If the printer has a heated bed then this parameter may be set. As with
the extruder temperature, the value will depend on the material used. A
rule of thumb is that PLA requires 35°C - 60°C and ABS requires 85°C.
Note: One may choose to control the bed temperature manually from
the printer controller. In this case the temperature can be set to zero.
Figure 2.7: Configuration Wizard: Bed Temperature
62

LulzBot Mini Specifications

General

Tweezers	Yes
Certification	CE, FCC, WEEE
Product color	Black, Green
Viewing window	No
Maximum print platform temperature	120 °C
Package weight	11330 g
AC input voltage	100/240 V
Power consumption (typical)	150 W
Print technology	-
Printing material	ABS, HIPS, Nylon, PVA, Polycarbonate (PC), Polylactic acid (PLA)
Layer thickness (max)	0.5 mm
Layer thickness (min)	0.05 mm
Maximum build size (WxDxH)	152 x 152 x 158 mm
Filament thickness supported	3 mm
Maximum vertical build speed	275 mm/sec
Printing compartment volume	3.65 L

Weight and Dimensions

Depth	435 mm
Width	340 mm
Height	385 mm
Weight	8550 g