EasyManua.ls Logo

LulzBot Mini - Configuration Wizard: Firmware Type

LulzBot Mini
148 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.3. FIRST PRINT
1. Firmware Type
The gcode produced by Slic3r is tailored to particular types of firmware.
The first step prompts for the firmware that the printer uses. For the Mini
3D printer select RepRap (Marlin/Sprinter)
Figure 2.2: Configuration Wizard: Firmware Type
57

Table of Contents

Other manuals for LulzBot Mini

Preview: Quick Start Guide
Quick Start Guide32 pages

Related product manuals