LulzBot Mini User Manual

GLOSSARY
Layer height The thickness of each individual deposited layer of the three-
dimensional model when cut with a slicing program.
Nozzle The metal tip at the bottom of the hot end. It has a small hole
where the plastic filament comes out of the printer.
PEEK Polyether ether ketone: an organic polymer used to insulate the hot
end due to its mechanical properties at elevated temperatures.
PEI Polyetherimide.
PTFE Polytetrafluoroethylene is a synthetic fluoropolymer used in the
Budaschnozzle for it’s low coefficient of friction.
RAMBo [R]epRap [A)]duino-[M]ega compatible [M]other [Bo]ard. De-
signed by Joynnyr of Ultimachine.
Thermistor A special type of resistor that changes resistance based on
temperature. It is used to measure temperature on the nozzle and the
heated bed.
Threaded extension Used to separate the heater block and nozzle from
the PEEK insulator. The plastic filament passes through the threaded
extension into the melting chamber.
146

LulzBot Mini Specifications

General

Tweezers	Yes
Certification	CE, FCC, WEEE
Product color	Black, Green
Viewing window	No
Maximum print platform temperature	120 °C
Package weight	11330 g
AC input voltage	100/240 V
Power consumption (typical)	150 W
Print technology	-
Printing material	ABS, HIPS, Nylon, PVA, Polycarbonate (PC), Polylactic acid (PLA)
Layer thickness (max)	0.5 mm
Layer thickness (min)	0.05 mm
Maximum build size (WxDxH)	152 x 152 x 158 mm
Filament thickness supported	3 mm
Maximum vertical build speed	275 mm/sec
Printing compartment volume	3.65 L

Weight and Dimensions

Depth	435 mm
Width	340 mm
Height	385 mm
Weight	8550 g