2.3. FIRST PRINT
If you are just beginning with 3D printing or Slic3r, LulzBot
™
recom-
mends starting with our pre-set Slic3r proles. You can nd the TAZ Slic3r
proles at https://www.lulzbot.com/Slic3r. For information on loading
and export Slic3r proles please see page 115. Note that the pre-set proles
will only work correctly when Slic3r is in Expert mode.
The pre-set proles will give you Slic3r settings that will work great on
most designs. The Slic3r manual can be used as a reference in building
knowledge of Slic3r settings while using the pre-set proles. Once you have
a number of prints completed you can use the Slic3r manual as a reference
to make small adjustments to the pre-set proles or begin creating your
own proles.
63
To Next Page
Loading...
