LUMENIS VersaPulse PowerSuite - Language Selection; Display Calibration Graphs; Display Pulse Energy Graphs; Fire for Fiber Position Check

9HUVD3XOVH3RZHU6XLWH6HULHV6HUYLFH0DQXDO 7+(25<2)23(5$7,21
5(9% 
4. Language Selection
This function will select the language to be used on the user-mode display. The setting will be stored in
NVRAM.
5. Control of Low-Energy Attenuator Position
This function will allow the user to move the low-energy attenuator into or out of the beam path.
6. Control of Safety-Shutter Function.
This function will allow the user to require the safety shutter to operate normally, or to lock it open or
closed.
7. Creation of reports.
This function will allow the user to generate specified reports about the system and transmit then from
the auxiliary serial port.
8. Display Calibration Graphs.
This function will allow the user to display the graphs of pump energy vs. pulse energy for each laser
individually, or for all lasers. The graphs for the individual lasers shall also show the limits allowed for
the calibration coefficients.
9. Display Pulse Energy Graphs.
This function will allow the user to display a graph of pulse energy for the most recent pulses from all
lasers. The user will be able to select whether the main energy readings or the safety energy readings
are displayed.
10. Fire for Fiber Position Check.
This function will allow the user to fire a number of pulses from each laser. The user will be able to
specify the number of pulses to be fired from each laser, which lasers are to fire, the pulse rate and the
pump energy to be used. It will not be possible to fire the Holmium and Nd:YAG laser at the same
time. When firing the Holmium lasers, the system will preheat the laser rods as for treatment firing,
then opens the shutter, fire the specified number of pulses and close the shutter.
When firing the Nd:YAG lasers, the system will open the shutter, firing the specified number of pulses
and close the shutter.