7+(25<2)23(5$7,21 9HUVD3XOVH3RZHU6XLWH6HULHV6HUYLFH0DQXDO
5(9%
11. Display System Information.
The following system information will be displayed, in addition to the other displays specified for ser-
vice mode:
• The measured output of the +5, ±15V power supplies.
• The coolant temperature and conductivity.
• The identification of the model in use.
•The ROM CRC value.
• The measured transmission of the low-energy attenuator at each wavelength present in the
system.
SERVICE MODE SCREENS
The following screens will implemented in service mode. Refer to Section 5 of this service manual for
illustrations of the different service screens:
1. Service 1.
This service screen contains the following controls and displays:
Pulse Rate
Flashlamp Voltage
PumpEnergy
Lamp Current
Ready/Standby
Laser Rod Enable/Disable
Laser Pulse Energy
Calibration Button
Burn-in Button
Initialize NVRAM Button
Next Screen Button
To Next Page
Loading...
