LUMENIS VersaPulse PowerSuite - 1.3 Serial Numbers

*(1(5$/,1)250$7,21 9HUVD3XOVH3RZHU6XLWH6HULHV6HUYLFH0DQXDO
 5(9%
operational amplifiers. The top op amp would be referred to as U1-1 (its output is pin 1) and the other would
be referred to as U1-7.
1.3 SERIAL NUMBERS
Serial numbers for the VersaPulse PowerSuite laser are in the following format:
MYPHWVXXX
where M is the month produced
(“A” is January, “B” is February, etc..)
Y is the last digit of the year produced
(0 is 2000, etc..)
P is a number indicating maximum system power
(9=100W, 6=60W, 4=45W, 3=30W)
( D=60W Ho/100W Nd, E=80W Ho/100W Nd)
H is the number of laser heads installed (1, 2, 3 or 4)
W is a number indicating the mix of rods intalled
(see below)
V is a number indicating power supply configuration
(1= 220VAC single phase)
2XXX is the number of the laser built
(2001, 2002, etc..)
W: 3 = Holmium only
4 = Ho/Nd:YAG
8
8
2
3
1
6
5
7