LUMENIS VersaPulse PowerSuite - 2.1.2 Unpack & Inspect Laser

,167$//$7,21 9HUVD3XOVH3RZHU6XLWH6HULHV6HUYLFH0DQXDO
 5(9%
2. Verify the AC mains voltage at the site.
Frequency: 50/60Hz
Voltage: 220 VAC ±10%
Current: 30A (32A for 100W Holmium)
Phase: Single (
I)
2.1.2 Unpack & Inspect Laser
1. Check the crate/carton for any shipping damage.
The shipper is responsible for any damage to the system in shipment. If the crate/carton appears to be
damaged, report the damage to the customer and shipper.
2. Remove the console and accessories from the crate (refer to Fig. 2.1).
a. Loosen the six butterfly clamps securing the side door and lower the side door (the side door is used
as a ramp to remove the console from the crate). Remove the protective foam and accessories box.
Install the ramps onto the base, then roll the unit down the ramps.
b. Return all packing material to the crate and save for future use.