LUMENIS VersaPulse PowerSuite - 2.1.3 Configure AC Control PCB

9HUVD3XOVH3RZHU6XLWH6HULHV6HUYLFH0DQXDO ,167$//$7,21
5(9% 
3. Move the system to its installation location.
The VersaPulse PowerSuite laser rolls best when pushed from the front handles. The front wheels
swivel, the rear wheels do not.
4. Open/remove covers and do a visual inspection of the interior.
Refer to Section 5 for information on removing the covers. Open the front cover, then remove the top
and two side covers. Inspect the interior carefully for loose or broken electrical or optical connections,
loose or broken plumbing connections, or any indication of shipping damage.
2.1.3 Configure AC Control PCB
Refer to Section 3.3.1 for additional details.
1. AC voltage configuration preparation.
a. Measure the mains voltage and record.
COVER RAMP
BUTTERFLY CLAMPS
(6) SECURE THE SIDE
DOOR
FOAM
PADDING (6)
INSIDE THE
CRATE
DISTILLED
WATER
ACCESSORY
BOX
FIG. 2.1
SHIPPING
CRATE