LUMENIS VersaPulse PowerSuite - Page 94

7+(25<2)23(5$7,21 9HUVD3XOVH3RZHU6XLWH6HULHV6HUYLFH0DQXDO
 5(9%
If the safety shutter is open, the system will display a message and remain in a Fault
State.
If the safety shutter appears to be defective (if both position sensors are in the same
state for more than a few seconds) the system will display a message and go to a Fault
state.
• Low Voltage Power Supplies
If the outputs of the low voltage power supplies are not within the specified tolerance
of nominal, the system will display a message and go to a Fault state.
• Debris Shield
If the debris shield is removed, the system will display a message and remain in a
Fault state.
When the debris shield is reinstalled, the system will go to Standby state automati-
cally.
• All Control Panel Buttons
The system will respond to control activations.
• Service Mode Enable Switch
If the Service Mode switch is toggled, the system will enter Service mode.
• Coolant Temperature and Conductivity
If the coolant temperature and conductivity are not within the specified limits, the
system will display a message and go to a Fault state.
• Inadvertent Exposure
If the system detects laser light when it is not firing, it will display a message and go
to a Fault state.