Lust CDA3000 - 3 User Interface and Data Structure; Data Structure

3-2
Application Manual CDA3000
3 User interface and data structure
3.1 Data structure For parameter setting, individual parameters, parameter groups in subject
areas or complete, predefined parameter data sets can be selected.
These preset parameter data sets are termed application data sets
(ADS). If the application data sets are modified by adaptations for the
customer, the results are user data sets (UDS). Parameters can only be
set in the active data set.
Figure 3.1 Data structure of the CDA3000
Explanatory notes:
• Parameters from subject area “_15 FC-Initial commissioning”.
• FS = Factory setting
Active
data set
RAM
Load with 165-UDSAC
Customer parameter setting
Load with 152-ASTER
Save with
150-SAVE
164-UDSWR
Traction and
lifting drive
001 MODE
999 xyz
Application data sets
(ADS)
ROM
001 MODE
999 xyz
Rotational
drive
(ROT_1)
Traction and
lifting drive
(DRV_1)
001 MODE
999 xyz
Bus
operation
(BUS_1)
001 MODE
999 xyz
Master/Slave
operation
(M-S_1)
001 MODE
999 xyz
User data sets
(UDS)
ROM
User
data set 4
User
data set 3
User
data set 2
User
data set 1
Fahr- und
lifting drive
Common
parameters
Charac-
teristic
CDS1
Charac-
teristic
CDS2
start
enter
stop
return
VAL
Hz
D
R
IV
E
-
M
A
N
A
G
E
R
WE=DRV_1 WE=DRV_1
WE=DRV_1 WE=DRV_1