Application Manual CDA3000
3-13
3 User interface and data structure
1
2
3
4
5
6
A
DE
EN
FR
3.4 Operation with
D
RIVEMANAGER
Connection and startup
• Connect the interface cable and switch on the power supply to the
drive unit.
• When the program starts the D
RIVEMANAGER automatically connects
to the attached drive unit (at least V2.3).
• If the connection setup does not occur automatically, check the set-
tings in the Tools > Options menu and start the connection setup
with the .
Figure 3.8 Connection via RS232 interface cable (9-pin, plug-and-socket)
The key functions
For more information refer to the DRIVEMANAGER Help.
Icon Function Menu
Edit parameters Active device > Change settings
Print parameter data
set
Active device > Print settings
Control drive
Active device > Control > Basic opera-
tion modes
Digital scope
Active device > Monitor > Quickly
changing digital scope values
Table 3.6 Functions of the DRIVEMANAGER
H1 H2 H3
X4
X2
X1
X3
ACHTUNG
Kondensatorent-
ladezeit >3 Min.
Betriebsanleitung
beachten!
WARNING
capacitor disscharge
time >3 minutes.
Pay attention to the
operation manual!
ATTENTION
temps de decharge
du condensteur
>3 min. observer le
mode dèmploi!
!
ANTRIEBSTECHNIK
SN.:
000.000.00000000
Typ:
Netz:
Ausg.:
D-35633 Lahnau
L3
U
V
W
RB+
RB
L-
L1
L2
D
RIVE
M
ANAGER
3m max.
RS232
RS232
X4
The quick route to a drive solu-
tion
To Next Page
Loading...
