Lust CDA3000 - 4 Application Data Sets; Preset Solutions

Application Manual CDA3000
4-1
4 Application data sets
1
2
3
4
5
6
A
DE
EN
FR
4 Application data sets
4.1 Activating an application data set .........................4-2
4.2 Selection of application data set ............................4-3
4.3 Traction and lifting drive ........................................4-7
4.3.1 DRV_1 .................................................................4-9
4.3.2 DRV_2 ...............................................................4-11
4.3.3 DRV_3 ...............................................................4-14
4.3.4 DRV_4 ...............................................................4-17
4.3.5 DRV_5 ...............................................................4-20
4.3.6 Comparison of parameters,
traction and lifting drive .....................................4-23
4.4 Rotational drive .....................................................4-26
4.0.1 ROT_1 ...............................................................4-28
4.0.2 ROT_2 ...............................................................4-30
4.0.3 ROT_3 ...............................................................4-32
4.0.4 ROT_4 ...............................................................4-35
4.0.5 Comparison of parameters, rotational drives ......4-37
4.5 Field bus operation ...............................................4-40
4.0.6 BUS_1 ...............................................................4-42
4.0.7 BUS_2 ...............................................................4-43
4.0.8 BUS_3 ...............................................................4-45
4.0.9 Comparison of parameters, field bus operation ..4-47
4.6 Master/-Slave operation .......................................4-49
4.0.10 M-S_1 ...............................................................4-53
4.0.11 M-S_2 ...............................................................4-55
4.0.12 M-S_3 ...............................................................4-57
4.0.13 M-S_4 ...............................................................4-59
4.0.14 Comparison of parameters,
Master/-Slave operation .....................................4-61
The inverter module contains preset solutions for the most frequent
applications (so-called “application data sets”). The object of these pre-
sets is to find the optimum device setup for the application with minimal
parameter setting.
Based on the application-specific basic settings for the “traction and lifting
drive” and “rotational drive” categories, all software functions relevant