4-2
Application Manual CDA3000
4 Application data sets
here are already optimized to those applications.
With additional basic settings the inverter module can be very easily be
preset for field bus operation or for network operation with several inver-
ter modules (Master/-Slave operation).
Within these four presets, the inverter module offers users the possibility
of selecting various control terminal settings. In this way the inputs and
outputs of the inverter module are adapted to the signals required in the
process.
With the total of 15 available presets the inverter module can be adapted
with a small number of parameters to virtually any application, thereby
greatly reducing commissioning times.
4.1 Activating an
application data
set
By means of assistance parameter 152-ASTER, in subject area “_15 FC-
Initial commissioning”, a preset application data set is activated in the
inverter module. This means that the presets for the application in que-
stion are loaded.
Parameter 151-ASTPR, in subject area “_15 FC-Initial commissioning”,
always retains the original device preset as its display value when an
application data set is edited.
Figure 4.1 Activating a preset with assistance parameter
152-ASTER
in subject area “_15 FC-Initial commissioning”
151-ASTPR
DRV_1
DRV_2
DRV_3
DRV_4
DRV_5
152-ASTER
Requirements of
the application
15 Application data sets
Best possible
presetting
BUS_1
BUS_2
BUS_3
ROT_1
ROT_2
ROT_3
M-S_1
M-S_2
M-S_3
M-S_4
5 x traction and
lifting drive
4 x rotational
drive
3 x field bus
operation
4 x Master/Slave
operation
ROT_4
To Next Page
Loading...
