3-4
Application Manual CDA3000
3 User interface and data structure
3.1.1 Application data
sets
Application data sets (ADS) are preset, complete parameter data sets
which are provided to handle a wide variety of application-typical move-
ment tasks.
Loading an application data set into the RAM automatically configures the
inverter module (see Figure 3.1). All subject areas, including the signal
processing inputs and outputs, are preset to the chosen solution.
Using an application data set makes commissioning of the inverter mod-
ule much quicker and easier. By changing individual parameters, the
application data sets can be adapted to the needs of the specific task.
These modified application data sets are stored in the device as user data
sets. In this way you can arrive more rapidly at your desired movement
solution.
A total of 15 application data sets cover the typical areas of application of
the CDA3000 inverter module.
Application data sets and typical applications:
Note: The factory setting (FS) is application data set 1 of the “trac-
tion and lifting drive” category. It is automatically loaded and
activated the first time the unit is started. After every subse-
quent start the selected user data set is loaded.
“Traction and lifting
drive”:
Conveyor belt, rack, trolley, spindle and
lifting gear drives
“Rotational drive”:
Spindle, extruder and Winding drives or
centrifuges
“Bus operation”:
Integration of the inverter system in a
network via CAN
Lust
,
CAN
open
or Profibus-DP
“ Master/-Slave
operation”:
Reference coupling of several inverter
modules
To Next Page
Loading...
