Lust CDA3000 - Loading Device Software

2-20
Application Manual CDA3000
2 Inverter module CDA3000
2.8 Loading device
software
Loading new device software
With the DRIVEMANAGER a new device software release (firmware) can be
loaded into the Flash-EPROM of the CDA3000. This means the software
can be updated without opening up the inverter module.
1. To perform the update, connect the D
RIVEMANAGER to the inverter
module.
2. From the Tools menu choose “Load device software (firmware) ...”.
The D
RIVEMANAGER then guides you through the further work steps.
LEDs H2 and H3 are lit steadily during transfer of the firmware. If the
transfer has been successful, LED H2 goes out when no ENPO sig-
nal is applied.
Device software damaged (Bootstrap)
The Bootstrap button is not designed for frequent use, and so should not
be pressed unnecessarily.
Note: Do not press the button beyond its contact point, otherwise it
may be permanently damaged.
If there is no software in the inverter module, or if the connection was cut
while a software release was being transferred, the following procedure is
required:
1. The required firmware (Hex file “3_xxx_xx.hex”) must be present.
2. Start the firmware transfer. From the D
RIVEMANAGER under Tools -
“Load device software (firmware) ...”.
3. Select device type “CDA3000 (frequency inverter)”.
4. FollowtheprompttosetthedevicetoBootstrapmode.
Bootstrap mode on the CDA3000: With the
Boot key (2) pressed down, tap the Reset button
(1) briefly once. LED H2 goes out, if it was previ-
ously lit.
(1)
H1 H2 H3
X4
CDA3000
(2)