3-8
Application Manual CDA3000
3 User interface and data structure
Changing user level
If a higher user level is selected by way of parameter 01-MODE, a prompt
for the associated password is automatically delivered. The password can
be changed by way of a password parameter in subject area “_36 KP-
K
EYPAD” (setting “000” = password disabled).
Changing the password for a user level
A password can only be changed for the authorized levels - passwords to
a higher user level cannot be viewed or changed. The password is
changed by selecting the parameter, editing it and then saving it by press-
ing the Enter key on the K
EYPAD KP 200. It can also be changed by way
of the D
RIVEMANAGER.
Note: Please make a note of any change of password and keep
your passwords safe from third parties.
Target group
Password
parameter
Comments
User level 01-
MODE
Password in
FS
1)
Layman No parameter
No access permission, for status monitoring only
• No parameter setting
• Display of basic parameters
1 -
Beginner 362-PSW2
With basic knowledge for minimal operation
• Expanded basic parameters editable
• Expanded parameter display
2 000
Advanced 363-PSW3
For commissioning and field bus connection
• Parameter setting for standard applications
• Expanded parameter display
3 000
Expert 364-PSW4
With control engineering skills
• All control parameters editable
• Expanded parameter display
4 000
Other 365-PSW5 For system integrators 5 -
Specialist
personnel
367-PSWCT For operation and commissioning by KEYPAD KP 200 CTRL menu 000
1)
FS = Factory setting
Table 3.3 Setting user levels via subject area “_36 KP-K
EYPAD”
To Next Page
Loading...
