Lynx NGT-9000 - CP-2500 Control Panel

Lynx
®
NGT-9000
Pilot’s Guide3-2
Operation - Remote Mount
CP-2500 CONTROL PANEL
The display of the CP-2500 shows the operational mode on the left
side of the display and the squawk code on the right side of the display
as shown in Figure 3-1.
The CP-2500 has the following standard functions: set operation
mode, set squawk code, and view current pressure altitude. The
following optional functions are part of the conguration options set
during installation of the Lynx NGT-9000R: set a ight ID mode, Trafc
functions, and TAWS functions.
In addition pressing the I button activates the IDENT, pressing the V
button changes the squawk code to a preset VFR code, and pressing
the M button provides access to the following functions: Info, set the
VFR Code, maintenance, TAWS inhibit (TAWS congured), TAWS
obstacle inhibit (TAWS congured), TAS mode (TAS congured and
on ground only). Details are provided below.
Notes
1. Refer to CP-2500 Pilot’s Guide (0040-17250-01) for
additional operational information.
2. The optional Flight ID function is available on the CP-
2500 if the Flight ID is congured via the DCM settings
during installation of the Lynx NGT-9000R.
4. If using the WiFi function, activate the PED and ight application.
Check that trafc and weather are operating properly. Based
on available ADS-B service, weather data and trafc may not
be seen. Note - NEXRAD updates are only transmitted every 5
minutes, and CONUS information every 15 minutes.
5. If the optional trafc and weather displays are ON (and
functioning), check display status. Based on available ADS-B
service, weather data and trafc may not be seen. Note - Some
trafc displays may show “DATA-FAIL” until the GPS signal is
acquired.