Lynx NGT-9000 Pilot's Guide

Lynx
®
NGT-9000
Pilot’s Guide 3-7
Operation - Remote Mount
Maintenance
Release 2.0 or greater
This menu item is available only when the aircraft is on ground.
1. Press the M (Menu) button.
2. Rotate the large knob to scroll the menu to Maintenance.
3. Press the small knob to enter “Self TST”.
4. Press the small knob again to activate self-test. When activated,
the screen momentarily displays “TEST STARTED” followed by
“TEST IN PROGRESS”.
• If the optional trafc or PED display is installed, each will show
three targets during the test.
• If the optional ADS-B Out Fail lamp is installed it will be
illuminated for 10 seconds during the test.
• The results can be test passed (display and audio) “TST PASS”,
test failed “TST FAIL”, or test degraded “TEST DEGRADED”
• If a failure is detected a fail message is ashed on the CP-
2500 screen for 5 seconds. The possible fail messages are
“NO LRU RESPONSE”, “XPDR FAIL”, “ADS-B OUT FAIL”,
“ADS-B IN FAIL”, “FIS-B FAIL”, “GPS FAIL”, “TAS FAIL”, “TAWS
FAIL”. Note - Release 1 of the NGT-9000 does not show the fail
message.
• If a degraded condition is detected a degraded message is
ashed on the CP-2500 screen for 5 seconds. The possible
degraded messages are “ADS-B OUT DEGRADED”, “ADS-B
IN DEGRADED”, “TAS DEGRADED”, “GPS INIT”, “CONFIG
MODULE - SERVICE SOON””. Note - Release 1 of the NGT-
9000 does not show the degraded message.
Inhibit TAWS Obstacles
The TAWS Obstacle option default setting is “Enabled”.
1. Press the M (Menu) button.
2. Rotate the large knob to scroll the menu to Obstacle
3. Press the small knob button to select.
4. Rotate the small knob to set the TAWS Obstacle mode to Enabled
or Inhibited
5. Press the small knob when done.
• Inhibiting TAWS Obstacles results in TAWS not including
obstacles as part of the alert detection.
• The message “OBST INHIBITED” is shown on the display
while the obstacle option is inhibited.

Lynx NGT-9000 Specifications

General

Brand	Lynx
Model	NGT-9000
Category	Security System
Language	English