Lynx
®
NGT-9000
Pilot’s Guide 2-51
Operation - Panel Mount
Aloft Button
This button is located on the left side of the screen and is labeled
“Aloft” with white text and the active selection labeled either “Wind”
or “Temp” with green text. Tap the button to select the other screen
function.
Panning
Press and hold an area of the screen that is not a button for 1 second
to activate the Panning function. Drag across the map to move the
map in that direction. Tap the Cancel Pan button to inactivate the
panning function.
Zoom Buttons
Zoom In (+) and Zoom Out (-) buttons are located on the bottom of
screen. The buttons are used to change the display range shown on
the display. Display range options are 10, 20, 50, 100, 200, 400, and
800.
Issue Valid Time Indication
This indicator is located at the bottom of the screen and is shown with
green text when a valid time is shown. The text is shown with yellow
text when the data is not valid or available.
Ownship Symbol
The ownship is shown as a white triangle when heading or track is
valid. When ownship direction source is not valid the ownship symbol
is a white circle with a black inset.
North Indicator
This indication is a white/green arrow located in the lower right corner
of the display. The indicator points to the top of the display when the
application is oriented north up.
Flight Level Selection
This is a vertical array of altitudes which is shown when the altitude is
pressed. Selection is done by tapping the screen on the value desired.
The values are in hundreds of feet.
When transitioning from one region to the other and the currently
selected ight level is not supported in the new region, the selected
ight level is reset to one that is supported.
To Next Page
Loading...
Need help?
General
