Lynx
®
NGT-9000
Pilot’s Guide 2-3
Operation - Panel Mount
System Status / Versions Screen
The system status is shown on the left screen and should show
“System Pass” in green text along with an audio indication of “System
Test Passed”. The version screen is located on the right side and
shows the software and database version information. See Figure 2-2.
Figure 2-2: Example of System Status / Version Screens
• If System Status is “System Fail”, then the message “Self-Test
Failures Occurred” is shown on the right side of the display and the
“System Test Failed” is heard through the aircraft audio system.
The option to restart the unit or to continue start up in a degraded
mode is shown on the right side of the display
• Tap the Restart button to restart the system.
• If the “System Fail” message continues to be seen tap the
Continue button to proceed. Refer to Chap. 5 (Troubleshooting)
for corrective actions.
• If System Status is “System Degraded”, then the message “See
MSG Window” is shown on the right side of the display.
• Tap Continue button to proceed. Refer to Chap. 5
(Troubleshooting) for corrective actions.
System Status
System Pass
Power On Result:
Versions
Flight Sw: 0000-00000-XXYZ
GPS/UAT RX: _ _ _ _ _ _ _
Airport DB: YYYYMMDD
Map DB: YYYYMMDD
TAWS DB: YYYYMMDD
To Next Page
Loading...
