Lynx NGT-9000 - FIS-B no Coverage Indicator; Figure 2-13: FIS Button

Lynx
®
NGT-9000
Pilot’s Guide 2-39
Operation - Panel Mount
FIS-B No Coverage Indicator
When congured to be enabled the indicator is located at the bottom
center of the screen and is shown when No FIS-B data is available in
the area (i.e. out of range of a ADS-B ground station).
• The indicator is also shown if a problem exists
with the NGT-9000 System. See the troubleshooting section.
When congured to be disabled, the Winds & Temps and FIS-B textual
data screens are deactivated and the FIS-B No Coverage Indicator is
disabled.
When congured for Auto FIS-B, the Winds & Temps and FIS-B textual
data screens are initially deactivated and the FIS-B No Coverage
Indicator is disabled. The Winds & Temps and FIS-B textual data
screens are activated and the FIS-B No Coverage Indicator enabled
when FIS-B weather messages have been detected. When FIS-B is
in operation a button is present on the screen that is used to disable/
enable FIS-B function. See Figure 2-13.
Figure 2-13: FIS Button