Lynx NGT-9000 Pilot's Guide

Lynx
®
NGT-9000
Pilot’s Guide3-8
Operation - Remote Mount
Display Messages
Messages being received from the Lynx NGT-9000R have priority over
normal display operation and are seen scrolling across the display.
• Entering the menu mode will momentarily stop the messaging to
allow access to the menu functions.
• Rotating the large knob scrolls through the prioritized messages
and the normal display operation (showing operational mode and
squawk code).
The display begins showing the highest priority message again after
10 seconds of no activity. The priority of the messages is discussed in
the CP-2500 Pilot’s Guide.
The following messages may be seen during normal operation. The
TAWS and Trafc messages are dependent on the installation options
setup for the Lynx NGT-9000R.
• NO LRU RESPONSE: The CP-2500 has detected loss of
communication with the Lynx NGT-9000R.
• GPS FAIL: The GPS derived position input is not functioning.
• GPS INIT: GPS Initialization –The GPS contained within the Lynx
NGT-9000R is not ready.
Release 1
This menu item is available only when the aircraft is on ground.
1. Press the M (Menu) button.
2. Rotate the large knob to scroll the menu to Maintenance.
3. Press small knob to view status “Self Test” “Disable” .
4. Turn the small knob to change status to “Enable”.
5. Press the small knob again to activate self test.
6. When activated, the screen momentarily displays “Test Started”
7. The results of the test are that during the test three targets are
shown on the optional Trafc or PED display and the ADS-B Out
Fail lamp ashes during the test.
• The results shown on the display can be test passed “TST
PASS” or test failed “TST FAIL”.
8. Press the M button to exit or scroll the large knob to “Done” and
then press small knob to exit and return to normal operation.

Lynx NGT-9000 Specifications

General

Brand	Lynx
Model	NGT-9000
Category	Security System
Language	English