Lynx NGT-9000 - Set VFR Code; View Info; Traffic Advisory Aural Acknowledge and Reply

Lynx
®
NGT-9000
Pilot’s Guide 3-5
Operation - Remote Mount
View Info
Available on ground only.
1. Press the M (Menu) button.
2. Rotate the large knob to scroll the menu to Info
3. Press the small knob button to select.
4. The Info menu option shows the following information about the
unit:
• Status (OK or FAIL)
• Hardware (HW Rev) conguration
• Firmware (FW Rev) conguration
5. Rotate the large knob to scroll through the information.
6. Scroll to “Done” and press the small knob to exit.
7. Press the M button to exit back to normal operation.
Set VFR Code
The VFR code can be changed from the default (always set to 1200
in the United States).
1. Press the M (Menu) button.
2. Rotate the large knob to scroll the menu to VFR
3. Press the small knob to select the rst digit.
4. Rotate the small knob to set the number.
5. Rotate the large knob to move the cursor to the next digit (4 total).
6. Press the small knob when done.
Traffic Advisory Aural Acknowledge and Reply
This function is a conguration option.
1. When a Trafc advisory is heard press the small knob button
to acknowledge the audio alert and cancel the current audio
message.
2. Press the small knob button again to replay the trafc advisory if
still available.
NOTE
The “TRAFFIC” message must be displayed when the button
is pressed to acknowledge or replay the aural.