262335 146 Revision A
RUN-UP PROCEDURE
5.14 Running up Header, page 119
Check hydraulic hose and wiring harness routing for
clearance when raising or lowering header and when
retracting or extending center-link.
—
Check knife speed. 5.15 Checking Knife Speed, page 125
Check that amber flasher and signal lights are functional.
5.13 Checking Lights, page 118
Check header ID on windrower.
—
POST RUN-UP CHECKS. STOP ENGINE.
Check for hydraulic leaks.
—
Check belt and chain drives for idler alignment and heated
bearings.
5.1 Checking Drive Belts and Chains, page 95
Check knife sections for discoloration caused by
misalignment of components.
5.16 Adjusting Knife and Guards, page 128
Check manuals in the right header endshield. 5.17 Checking Manuals, page 130
Date Checked: Checked by:
REFERENCE
To Next Page
Loading...
